The 98-104 Six Arm Spider Rotor from Riverside Products, Bettendorf, Iowa, is constructed out of cast alloy.
• The rotor shaft is a fully machined, certified vacuum degassed rotor shaft.
• Approximate weight is 56,000 pounds without the hammers, hammer pins, pin protectors or spider caps.
• The rotor uses 39 spider caps and normally runs a 16-hammer pattern.
More information is available by visiting Riverside Products online at www.RiversideProducts.com or calling the company at (800) 545-6221.
Get curated news on YOUR industry.
Enter your email to receive our newsletters.
Loading...

Explore the June 2007 Issue
Check out more from this issue and find your next story to read.
Latest from Recycling Today
- Buy Scrap Software to showcase its software at Scrap Expo in September
- LG details recycling activities
- Algoma EAF is up and running
- Toyota-Tsusho completes acquisition of Radius Recycling
- CATL, Ellen MacArthur Foundation aim to accelerate circular battery economy
- Commentary: Expanded polystyrene is 98 percent air, 2 percent plastic and 100 percent misunderstood
- AMCS appoints general manager for North America
- How tariffs, regulations affect LIBs recycling in US, EU